Dolphin 9950 Betriebsanweisung PDF herunterladen (Seite 153)

Dolphin® 9500 Series Mobile Computer User’s Guide 7 - 37

Profile Info Tab

WEP Mgmt Tab

The WEP Mgmt tab enables you to set WEP parameters for each port.

Field Description

Network Profile

Enter the name of this record. This is the name that appears in the Configured Networks list and,

by default, is the same as the broadcast SSID. Note that there is nothing special about the name

"default". You could configure any other record similarly and it would behave the same way.

Network Name

This is the SSID of the access point. If the access point broadcasts its SSID, then this value may

be derived from the Available Networks list. If the SSID does not broadcast, then you must

manually enter the value here.

Peer-to-Peer Group

(ad hoc mode):

Select this option to have two or more client workstations communicate with each other without

the benefit of an access point.

You should also select Do Active Scan and, in the WEP Management page, enable Use key

for data encryption while entering a common key for both sides.

WPA is not supported in this mode.

Do active scan

Select this option whenever the access point (or client, for ad hoc mode) is not broadcasting its

SSID.

Authentication Profile

Select the Client Configuration (user) profile associated with this network. The drop-down list

contains client profile names created in the User tab of the Client Configuration Area;

see User

Tab on page 7-27.

To open the selected profile, select it in the drop-down list and tap View. The User tab opens

displaying the profile details. If you tap OK (to save changes) or Cancel, you are returned to the

Profile Info tab.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 313 314

Keine Kommentare

Dolphin 9950 Betriebsanweisung Seite 153